All About That Brass

It looks like brass is back in – bright, shiny, golden brass. The last few jobs we have done featured plenty of brass, and they have been for customers who I would say are “in the know” for design trends. The styles are less decorative than previous iterations, but I am surprised by how quick it is back. It seems like just yesterday we were taking out everything that resembled brass and replacing it with oil-rubbed bronze. I guess there are only so many choices, and brass isn’t a bad one.

A great example of the brass trend roaring back are a couple sets of cabinets we have done lately which featured brass, not only in the hardware choices, but also added to the cabinets. We have previously done a set in black and just recently a set in walnut. The brass inlay is a fancy touch which isn’t too hard to pull off, but there are a few tricks which we figured out through a bit of trial and error.

The first set of doors and drawer fronts set we did were made from mdf with the grooves routed on the cnc router. We used 1/8″ thick brass and super glued them in the grooves after we chiseled the corners square. It worked well, but we planned to sand the entire panel in the wide-belt sander and that’s where things went a little sideways. Even with the lightest and quickest of passes, the brass would get hot and expand and then pop out of the grooves. We were able to finish up by hand, using a block backer behind the sandpaper, but the process took quite awhile. Luckily, we were only doing a handful of doors. In case you are wondering, the orbital sander was a no-go because the brass and mdf sand at different rates and the orbital sander would leave the brass high and the mdf low, resulting in a non-flat surface. The only way to ensure a flat surface is with very even amounts of sanding through the wide-belt sander or with a stiff backer behind the sandpaper.

On our most recent set of walnut cabinets, I decided to step up the brass to 1/4″ x 1/4″ and it made a huge difference. We were able to put the panels through the wide-belt sander (still taking light passes) and have that be our almost finished surface. We then very, very lightly sanded with the orbital sander just to get the brass surface finished consistently, but had no issues with the brass wanting to pop out of the grooves. The structural difference between 1/8″ thick and 1/4″ thick brass and its ability to dissipate heat, both added to the success. I think it also helped to have more glue surface on the side of the brass to keep them in place.

The walnut panels were a bit easier to finish than the black set because the entire panel was only clear coated for the finish. The black set required us to tape off the brass before painting black and then clear coating the entire panel. To get a perfectly flat finish, the black set also took a few extra coats of finish with 320 sanding in between to level out the surface.

Besides the brass hardware, brass is finding its way back in fixtures and accent pieces too. We found ourselves also working on a set of brass and walnut shelves to accompany the cabinets above. It seems like the brass is coming back and designers are not being shy about using it. Take a good look around the internet and you’ll find brass, and it will be as big as ever.