I have been on a sycamore kick lately, and this sycamore slice keeps my streak going. There are three stacks of these rough sawn slices for sale in my shop, and though I have sold a few, this is the first one to officially get finished and installed.
Luckily the house had a perfect niche for this 48″ diameter hollow sycamore log slice.
The slice is 3″ thick and is a cross cut of a 48″ diameter hollow sycamore log that had the added benefit of having a long open wound that didn’t quite seal up. In the tree’s attempt to close the wound the new wood took on a curl shape on both ends that make the slice look more like an artistic expression than just a hollow log.
Since the tree was standing dead all of the sapwood is consistently spalted and marbled in appearance. There is some solid heartwood in the piece which isn’t spalted, but has a beautiful rust color.
I was planning on ditching this tree since it was hollow and didn’t seem to have any millable lumber in it, but when I saw the curl shape on the inside of the log I did a u-turn on my way to the dump. Solid logs with complete centers that are sliced like this tend to crack and fall apart because of the drying stresses in the log, but in this case all of the drying stresses were relieved since the center was gone. When the outside wood wanted to shrink it wasn’t restricted by wood on the inside and could freely reduce in diameter without any problems.
I installed the slice on the wall with two lag screws, just like a mantel. I drilled matching holes on the back of the wood and just slid it on the wall (with the help of my customer). This system works great since it allows the piece to get flush to the wall and enables it to be removed without tools should the need arise.
Overall, I am ecstatic to have one of these completed and out the door. Next up is to finish at least one extra to keep in the shop to show off. You wouldn’t believe how much faster they sell with a finished sample around to seal the deal.